Tại sao máy tính của tôi cài driver âm thanh rùi mà vẫn ko nghe đc nhạc??? tôi khẩn khoản noờ mọi người giúp tôi!!!

Đây là tất cả về máy tôi: Specifications: CPU Support: Socket 478 Intel Pentium 4 in the 478 pin package Chipsets: (North) VIA P4X266A Support Pentium 4 System bus Support PC100 / 133 SDRAM interface Support AGP interface Support V-Link interface to VT8233 Support ACPI 1.0b compliant power management Support APM 1.2 compliant power management (South) VIA VT8233 Built in high bandwidth 266MB/S 8-bit V-link Host controller Integrated Fast Ethernet Controller with 1/10/100Mb capability Integrated USB controller with three root hub and six function ports Integrated dual channel UDMA 33/66/100 master mode EIDE controller LPC interface for Low Pin Count interface to Super-I/O or ROM Integrated Keyboard Controller with PS2 mouse support Integrated DS12885-style Real Time Clock with extended 256 byte CMOS RAM and Day/Month Alarm for ACPI System Management Bus Interface Sophisticated PC99-Compatible Mobile Power Management Integrated Plug and Play Controller Front Side Bus 100/133 Mhz (BIOS adjustable) 400 Mhz (NetBurst) Form Factor ATX Memory: 3 x 168 pin SDRAM Socket Support PC 100/133 compliant SDRAM up to 1.5GB (un-buffered) capacity Support PC 100/133 compliant SDRAM up to 3GB (registered) capacity Audio: AC97 audio AC'97 2.2 compliant CODEC on board Expansion Slot Support both AGP 1.5/3.3V electrical signal Support 1X, 2X, 4X AGP data transfer 5 x PCI slots PCI 2.2 compliant, 32-bit BUS Master Slots 133 Mbyte / sec maximum throughput 1 x CNR Riser Support CNR riser card for Modem function IDE: Built in VT8233 l 2 x UltraDMA/100 Bus Master IDE Channel from VT8233 ATAPI IDE CD-ROM, CD-R, CD-RW, and LS-120 Supports LPC I/O: ITE 8705F Comply with Intel Low Pin Count Interface Specification Rev. 1.0 ACPI V. 1.0 compliant Built in H/W monitor feature Two 16C550 UARTs * Supports two standard Serial Ports * Supports IrDA 1.0/ASKIR protocols * Supports Smart Card Reader protocols Built in Smart Card Reader IEEE 1284 Parallel Port * Standard mode -- Bi-directional SPP compliant * Enhanced mode -- EPP V. 1.7 and V. 1.9 compliant * High speed mode -- ECP, IEEE 1284 compliant Floppy Disk Controller * Supports two 360K/ 720K/ 1.2M/ 1.44M/ 2.88M floppy disk drives * Enhanced digital data separator * 3-Mode drives supported Keyboard Controller Game Port Dedicated MIDI Interface Support power-failure resume and power button de-bounce H/W Monitoring: Built in ITE 8705F 2 thermal inputs from remote thermal resistor to monitor system temperature 1 thermal inputs from thermal diode to monitor CPU temperature 8 voltage monitor inputs 1 chassis intrusion input Monitors 3 fan tachometer inputs Smart Guardian Controller to provide programmable fan speed automatic control Power Management APM 1.2 compliant ACPI 1.0 compliant Support multiple system suspend types- suspend to DRAM, suspend to disk, and all with hardware automatic wake-up Bios: Award PnP BIOS Stored in 2 Mb flash memory SMBios 2.3 BIOS FSB setting from 100/103/107/110/133/134/137/140/142/145MHz Support IRQ manual assign table Bootable from Floppy, ATAPI device, USB device, SCSI device On Board Ports / Connectors / Jumpers / Headers (front/back panel) Ports: Back Panel: 2 Serial Ports 1 Parallel Port (SPP, EPP, ECP) 1 PS/2 Keyboard Port 1 PS/2 Mouse Port 2 USB Ports 1x Game / MIDI Port 1x Line in, 1x Line out, 1x Mic Connectors: 1 x ATX power connector 2 x Fan Power connectors 2 x UltraDMA/100 Bus Master IDE 1 x Floppy Jumpers: Clear CMOS BIOS flash block protection Headers: 2 sets of dual Front Panel USB header Audio header (MIC/speaker-out) 2 x CD_in Wake On LAN Wake On Modem SIR Other Features: Suspend switch and LED Accessory 1 CD-ROM Disk: VIA 4 in 1 Driver VIA Audio driver User manuals in PDF format IDE Cable: 1 x ATA 100/66 cable Floppy Cable: 1 x Floppy cable User manual: 1 printed user manual Other: Chipset heat sink Đó!!!!! tôi cài xong rùi nó ko chạy đc// Nó hiện lên lỗi ở windows media mọi người giúp tôi