Mô tả sản phẩm: Thiết bị đo lực Imada MX Series
Motorized Test Stand |
Manual Test Stand |
||||
Able to make measurement speed and direction steady. Fit for durability test. Recommended for measurements according to kinds of standards |
Low cost / High working property |
||||
V ertical |
Horizontal |
|
V ertical |
Horizontal |
Small/Unique |
Able to do various kinds of test such as compression, tensile, peeling and so on. Space-saving. |
Easy to set up / take off sample |
Handle Operation |
Able to add force more steadily. |
Easy to set up / take off sample |
Fit for low capacity / hand-use |
SV H, HV series |
SH series |
KV , MS series |
|||
Lever Operation |
Able to do compression/tensile test more efficiently |
|
|||
MX series MX2 series EMX series |
MH series ML series |
||||
SV L series |
<Comparative Table of Features>
[Motorized Vertical Test Stand]
Model |
MX series |
MX2series |
EMX series |
Features |
Popular |
Standard |
High-Spec |
Index of selection |
For those who prefer low cost and simple operation. |
For those who demand to do repetition/ durability test. For those who would like to measure more precisely. |
For those who would like to do complicated measurement more precisely. For those who demand to analyze force-displacement. *1 |
*1 Force-displacement unit (FS-Master) is necessary for displacement output.
[Motorized Vertical Test Stand]
Model |
MX series |
MX2series |
EMX series |
|
Structure |
Flame axial stiffness |
― |
Stiffer than MX series |
Stiffer than MX2 series |
Capacity |
500N, 1000N, 5000N |
500N, 1000N, 2500N |
1000N |
|
Speed (mm/min) |
10-300(500N/5000N) 8-240(1000N) |
10-300 |
0.5-600 |
|
Front part shield |
― |
Yes |
Yes |
|
Function |
Manual operating mode |
Yes |
Yes |
Yes |
Single cycle mode |
Yes |
Yes |
Yes |
|
Continuous cycle mode |
Yes |
Yes |
Yes |
|
Counter *2 |
― |
Yes |
Yes |
|
Timer *3 |
― |
Yes |
Yes |
|
Speed/ Travel Setup |
Travel range setup |
Yes |
Yes |
Yes |
Digital setup of travel |
― |
― |
Yes |
|
Digital setup od speed |
― |
Yes |
Yes |
|
Setup of speed change point |
Yes (5000N only) |
― |
Yes |
|
Control function |
Overload prevention *4 |
Yes |
Yes |
Yes |
Force control *4 |
Yes |
Yes |
Yes |
|
Emergency stop |
Yes |
Yes |
Yes |
|
Control signal in/output |
― |
― |
Yes |